Tech Tip - Fusion Mix Chamber
Posted By DEMILEC
Mix Chambers for the Fusion Gun: Always make sure to check and properly
clean your mixing chamber using only the proper drill bits that come with
the mixing chamber. Using the wrong size drill bit will cause over size
ports and can distort your spray pattern resulting in uneven patterns
and can affect your yield.
Using a pin vise, not a power drill, insert the large drill bit into the
front of the mixing chamber to clean out your pattern control. Do so carefully
so that you do not break the drill bit inside. Flip your pin vise over
and using the smaller drill bit, clean out the side holes. Remember not
to go all the way thru as the holes are off set to create a mixing vortex.
If scratches appear on the surface of the mixing chamber, use 1000, or
higher, grit wet/dry sandpaper to lightly buff out the scratches.
Always spray a test pattern on the floor to check your pattern before starting
to spray. If your pattern is not a clean round pattern, stop and clean
or replace the mixing chamber.
As always read, understand and follow all instruction manuals and warning
labels supplied with all equipment. Only trained and qualified personnel
should perform repairs on the equipment. To access the latest equipment